e-licktronic Forum

lsdave

Opened it up and I'm now getting 3.7v on the 5v lines coming off the power board and I believe it's the 5v that runs the sequencer. It appears as though the headsink slipped down on the regulator and bridged the 3 prongs causing a short. Going to rebuild the power section and go from there. Just a ...

lsdave

I have one i could sell, $10 plus shipping? I am in Canada

lsdave

Op amp was fine. Nothing else damaged.

lsdave

I never used their software before so it's a bit difficult to check all the alignments, but all the cutouts look correct. If you copied everything straight from the ai file from e-lick, all dimensions should be correct too, the only thing you need to make sure of is that the holes on the IO plate a...

lsdave

Yes, that is to accommodate the side profiles.

I will have to double check allignment of the back plate holes to make sure there is no stress on the ribbon cable.

lsdave

If he is not up for doing another enclosure run, i've been looking at other feasible options. I used the layout files on the forums here to mock up a full enclosure using Front Panel Express.(minus a bottom cover as i can have that made locally for much less. Just needs to be a 1.5mm piece of metal ...

lsdave

I used the layout files on the forums here to mock up a full enclosure(minus a bottom cover as i can have that made locally for much less). these are the files I've come up with. If someone could look over them to see if they think anything is wrong, i would appreciate the feedback as this is the fi...

lsdave

Ill take one as well.

lsdave

seems like i had a bad q35. I replaced it with another NPN with the same ECB pinout and now i get between 200-750mV. I'm going to play with R127 now to see if i can get it to 130mV.

lsdave

What are some of your guys voltages on pin 2 and 3 of the opamp?

Search found 17 matches

Re: Sequencer issue

Re: Any Spare Overlays for Sale

Re: R208 and R209 burning up!

Re: Front Panel Express enclosure.

Re: Front Panel Express enclosure.

Re: Exploring other enclosure options.

Front Panel Express enclosure.

Re: Exploring other enclosure options.

Re: Noise section trimmer voltage?

Re: Noise section trimmer voltage?