e-licktronic Forum

istel

Hi everyone

I have a standard 909 grey nava case for sale. I will sell it for 50 eur including shipping. It's currently located in Scandinavia.. Pm me if you are interested..

istel

No one? Vincent? The quality of v1.0 and v1.01a boards is pretty poor. Many users - including me - reported all sorts of issues due to broken traces. Download the PCB Silkscreen files and check the traces in the sequencer section, especially those around IC110. Also check your cabling. Okay, I have...

istel

No one? Vincent?

istel

Tried to update via SysEx.. I used the C6 program from Elektron and it seems to be doing the update, but it stalls at this point and when i restart it all LEDS are on.. After update seems to be done https://i.imgur.com/o7yYZg0.jpg After restart https://i.imgur.com/mdizYeZ.jpg After I restart once ag...

istel

Hi there So, I was building the Nava quite a while ago, but I had to move and many other things got in the way and I finally have time to sit down and work on it again, but I am stuck as there is some things that are not working properly. My display isn't working, though the backlight does. My seque...

istel

Right, I do have a TL074 from the BOM that I ordered..

Hmm, ok, but well TL074 work in conjunction with the MUX_SH board? A bit confusing.. Maybe I should just try it out and see what happens

istel

Ok, so hopefully this is my last question in this forum ;) It's specified in the build tutorial: " IC110 (TL074) has been replaced by IC1 (TL072) " I can't find IC1 anywhere on my board, so I suspect that means that IC110 is to be replaced by TL072. What I can't figure out is, how should i...

istel

Quick update; my error was not connecting J1 to J11 - now it works fine here. From e-lick himself:

The ground come from the mainboard to io board J11 pin 4 then from the io board to Master section on J14 Pin2

istel

Did a little more digging around and I am suspecting this issue has something to do with R40, which isn't on my 1.01a board, but is apparently on the 1.02 board. This has something to do with analog and digital ground as far as i can understand. http://www.e-licktronic.com/forum/viewtopic.php?f=24&a...

istel

I built the whole IO board and sequencer, then I built each individual voice. This allowed me to test each voice as I went along. You can essentially follow the Yocto2 build guide (with some fairly obvious modifications). Cheers mate. I am proceeding. Have a little problem with GND on the master se...

Search found 19 matches

Nava standard 909 case for sale in Scandinavia

Re: v1.01a troubleshooting (no display, but seq. is good)

Re: v1.01a troubleshooting (no display, but seq. is good)

Re: v1.01a troubleshooting (no display, but seq. is good)

v1.01a troubleshooting (no display, but seq. is good)

Re: TL072 on IC110 on 1.01a board

TL072 on IC110 on 1.01a board

Re: Master section voltages (GND from J6 or J8?)

Re: Master section voltages (GND from J6 or J8?)

Re: Testing voices with arduino - do I need 5v to acc?