Accent:
Here is the part list:
Image | Description | Part | Value | Qty |
Ceramic capacitor (22) | C201 | 22p | 1 | |
Polyester capacitor (2A102J) | C23, C27 | 1n | 2 | |
Electrolytic capacitor | C25, C34 | 47/16 | 2 | |
Quad 2-input NAND | IC6 | 4011N | 1 | |
NPN Silicon Transistor | Q27, Q31, Q32, Q33, Q34 | 2SC945 | 5 | |
1/4w Carbon resistor | R92, R119 | 22K | 2 | |
1/4w Carbon resistor | R93, R118 | 10K | 2 | |
1/4w Carbon resistor | R97, R122 | 33K | 2 | |
1/4w Carbon resistor | R100, R102 | 680K | 2 | |
1/4w Carbon resistor | R101 | 100K | 1 | |
1/4w Carbon resistor | R112 | 3K3 | 1 | |
1/4w Carbon resistor | R113, R114, R120 | 4K7 | 3 | |
1/4w Carbon resistor | R117 | 47K | 1 | |
1/4w Carbon resistor | R121 | 100R | 1 | |
1/4w Carbon resistor | R123 | 15K | 1 | |
Potentiometer (B103) | VR3 | 10KB | 1 |
Make it:
![]() | Here is the part about the Accent. Each instrument is defined by a dotted box. |
![]() | Solder all resisotrs |
![]() | Solder polyesterscapacitors the electrolytics capacitors |
![]() | Place transistors. Do not get confused between 2SA733 and 2SC945 it is not the same transistors.
MAKE SURE TRANSISTORS ARE IN THE RIGHT WAY |
![]() | Test 4011power supply . The black dot is the ground, the red dots are +15 V (plus or minus 5%). Always check that the four power wires are well connected. THEN DONT FORGET TO DISCONNECT THE POWER TRANSFORMER. DO NOT SOLDER COMPONENT AS THE CIRCUIT IS POWERED ! |
![]() | Solder the 4011. To insert it into the PCB you have to bend the leads a little. |
![]() | Finally return the PCB and solder potentiometer on the opposite side of components. DO NO WRONG IN THE VALUE OF POT, MARK MUST BE ABOVE: B103 You can then go to BassDrum assembly |
Follow us